150mm IR Sensor Tap

TSL.884

Welcome to the support page for the TSL.884 150mm IR Sensor Tap. On this page you’ll find video guides to repairs, common fixes, and general repairs. Plus there is a list of FAQs you may find helpful. If none of this answers your question. Please don’t hesitate to get in touch.

FAQs

What is the current lead time on your products?

The average lead time on all our products is currently 6 to 8 weeks.

The tap will not shut off, what can I do?

There are two main causes of a sensor tap running constantly.

No power to the sensor. If the valve is in the open position and there is no power the valve may not be able to close. Please check there is 230v power to the power pack and there is 6v power from the power pack to the sensor.

Dirt or debris in the valve housing can prevent the diaphragm from creating a full seal. If this is the issue you are experiencing the flow rate should not be full rate. Following the cleaning guide in Why is my tap dripping and how do I fix it, which should resolve this issue.

What water pressure do your taps require?

Our solenoid valves work within a dynamic pressure of 0.5-8 Bar (7.3-116psi). To achieve optimal flow rate from the tap a regulated pressure of 3 bar(43.8psi) is recommended, pressures lower or higher than this will decrease the flow rate from the tap.

Pressures outside of the range may prevent the valve from opening and closing.

Can I adjust the temperature of the tap?

All of our taps are supplied by a mixed water supply via a Thermostatic Mixing Valve (not supplied) as part of the washrooms plumbing. There are no temperature controls within the tap, the temperature can only be adjusted via the TMV.

Where can I obtain spare parts?

Any spare parts related to your product can be found above. If you would like to see our full range of spare parts please click here.

Do you offer an installation service?

Yes, we can offer an installation service to suit your needs. Please contact technical@thesplashlab.com with details of your requirements and we will be happy to assist.

Common fixes

How to change the aerator


These videos are The Splash Lab TSL recommendations and any work, especially on electrical products, must be undertaken by a qualified professional. The Splash Lab (TSL) is not responsible for any event because of following the instructions in these videos 

How to change the solenoid valve


These videos are The Splash Lab TSL recommendations and any work, especially on electrical products, must be undertaken by a qualified professional. The Splash Lab (TSL) is not responsible for any event because of following the instructions in these videos 

How to clean the solenoid valve


These videos are The Splash Lab TSL recommendations and any work, especially on electrical products, must be undertaken by a qualified professional. The Splash Lab (TSL) is not responsible for any event because of following the instructions in these videos 

How to change the sensor


These videos are The Splash Lab TSL recommendations and any work, especially on electrical products, must be undertaken by a qualified professional. The Splash Lab (TSL) is not responsible for any event because of following the instructions in these videos