150mm Capacitive Sensor Tap


Welcome to the support page for the TSL.883 150mm Capacitive sensor tap. On this page you’ll find video guides to repairs, common fixes, and general repairs. Plus there is a list of FAQs you may find helpful. If none of this answers your question. Please don’t hesitate to get in touch.


What is the current lead time on your products?

The average lead time on all our products is currently 6 to 8 weeks.

What water pressure do your taps require?

Our solenoid valves work within a dynamic pressure of 0.5-8 Bar (7.3-116psi). To achieve optimal flow rate from the tap a regulated pressure of 3 bar(43.8psi) is recommended, pressures lower or higher than this will decrease the flow rate from the tap.

Pressures outside of the range may prevent the valve from opening and closing.

Can I adjust the temperature of the tap?

All of our taps are supplied by a mixed water supply via a Thermostatic Mixing Valve (not supplied) as part of the washrooms plumbing. There are no temperature controls within the tap, the temperature can only be adjusted via the TMV.

Where can I obtain spare parts?

Any spare parts related to your product can be found above. If you would like to see our full range of spare parts please click here.

Do you offer an installation service?

Yes, we can offer an installation service to suit your needs. Please contact technical@thesplashlab.com with details of your requirements and we will be happy to assist.